*  Machine cover is essential to minimize the injuries by flying broken blades.

* Irrelevant people are not allowed in the work shop.

* Flammables and explosives should be kept away from the work floor.

 

Safety Measures

* Wear glasses when working, to prevent from injuries by broken blades.

* Watch out for your ties and sleeves. Long hair should be kept inside the cap, and no gloves are allowed during operation.

 

Before Use

* Ensure the machines are in good condition with no deformation and no spindle vibration, the spindle's running tolerance can h7.

* Make sure the blades are not excessively worn-out, blade body has no deformation or breaks lest injuries occur.

* Make sure appropriate saw blades are used.

 

Installation

* Ensure the saw blade turns in the same direction as the spindle does. If not, accidents are likely to occur.

* Choose the flange whose inner diameter is the same as that  of the saw blade but the outer diameter is a little larger than 1/3 (for multi-rip saw blade is 1/2) of the saw blade. Ensure the flange is clean, not over worn, bent and distorted shape.

* Check the tolerance between the saw blade and the spindle. Install the flange and fasten the screw.

* Be sure no people stand in front of the machine when starting the machine. Do not feed, just to check whether there is a vibration, radial or axial run out.

*Saw blade reprocessing such as bore trimming or re-boring, should be finished by the factory. Poor reprocessing would lead to poor quality and may cause injuries.

*While installation, the saw blade should be 5-6 teeth higher than the board surface.

 

In Use

* In operation wood materials should be properly fixed lest abnormal cutting occurs.

? The operation must be stopped rightly once unusual nose and vibration occurs, if not, rough surface and tip-breaking many occur.

 

After Use

* Saw blade should be re-sharpened because dull saw blades many affect cutting effect and lead to accidents.

*Re-sharpening should be made by professional factories, not changing the original teeth angle degrees.

CL400

Model: CL400

Motor: 220v/50hz, 22002, 2860r/min, IP54

Cutting diameter: 30~125mm

Max. length of log to cut: 0.8meter

Blade: 400x30x3mm

N.W./G.W.: 37kgs/42kgs

Packing size (LxWxH): 112x91.5x62cm

Container loading: 66pcs/20ft container, 176pcs/40ft container